Table of Contents
Advertisement
3
Installing the Bagger Bracket
(Z400 Mowers with 52-inch
Mower Decks)
Parts needed for this procedure:
1
Bagger bracket
8
Bolt (5/16 x 1 inch)
8
Flange nut (5/16 inch)
Procedure
Note: Use these instructions if machine is equipped with
a rear weight.
1. Remove the rear weight from the back of the machine
(Figure
10).
Note: Save the bolts and flange nuts.
Figure 10
1. Bolt
2. Flange nut
3. Rear bumper
Note: Make sure to install the bagger bracket correctly,
as shown in
Figure
4. Engine-guard strap
5. Rear weight
11.
1. Correct position
2. Install the bagger bracket and weight to the engine
straps, tailpipe guard, and rear bumper with the 8
existing bolts and nuts previously removed
1. Bagger bracket
2. Bolt
3. Flange nut
8
Figure 11
2. Incorrect position
(Figure
Figure 12
4. Rear bumper
5. Engine-guard strap
6. Rear weight
12).
Advertisement
Table of Contents
