Agitator Kit Accessory - Graco WB3000 Instructions - Parts Manual

Installation

Agitator Kit Accessory

To add an agitator to the Graco isolation system, order
Part No. 245895. See
for the kit parts list.
1. Discharge the system voltage (see
Discharge and Grounding Procedure, page
2. Relieve the pressure (see
Pressure Relief Procedure, page
3. Open the isolated enclosure door.
4. Remove the back of the control box (258).
5. Remove tube (A2) from elbow (282) at the air
manifold; see . Install the Y fitting (402) into
the elbow. Install tubes (A2) and (407) into the
Y fitting. Route the agitator tube (407) into the
cabinet.
6. Replace the back of the control box (258).
7. Assemble the other parts of the kit as shown.
Secure the agitator with the setscrew (408).
8. Return the system to service.
20
245895 Agitator Kit, page
Fluid Voltage
26).
75,
25).
Figure 13 245895 Agitator Kit
3A2497C