245895 Agitator Kit - Graco OR PRO TI1681A Instructions-Parts List Manual

Installation
c. Connect the end of the tube (T) to the pump
fluid outlet fitting (Z).
CAUTION
The Graco warranty is void if the spray gun is con-
nected to a non-Graco voltage isolation system or if
the gun is operated above 60 kV.
CAUTION
Factory Mutual approval is valid only when this gun is
used with Factory Mutual approved voltage isolation
systems.

245895 Agitator Kit

To add an agitator to the Graco isolation system, order
Part No. 245895. See page 67 for the kit parts list.
1. Discharge the system voltage (page 20).
2. Relieve the pressure (page 20).
3. Open the isolated enclosure door.
4. Remove the back of the control box (258).
5. Remove tube (A2) from elbow (282) at the air mani-
fold; see the tubing diagram on page 64. Install the
Y fitting (402) into the elbow. Install tubes (A2) and
(407) into the Y fitting. See F
tor tube (407) into the cabinet.
6. Replace the back of the control box (258).
14
. 11.. Route the agita-
IG
7. Assemble the other parts of the kit as shown.
Secure the agitator with the setscrew (408).
8. Return the system to service.
407
401
406
403
408
404
406 (Ref)
Fig. 11. 245895 Agitator Kit
Connect to elbow (282)
inside control box (258)
402
Install tube A2 here
TI2137A
309293J