Connecting The Acoustimass Module To The Media Center - Bose LIFESTYLE 18 II Series Quick Setup Manual

Connecting the Acoustimass® module
to
the media center
Connect the Acoustimass module to the media center with the audio input cable (Figure 11).
) Note: Be sure that each connector is fully inserted into each jack.
1. You may find it easier to insert the power adapter cord into the media center first. Do not
plug the other end into an AC (mains) power outlet until all connections are completed.
2. Plug the small black multi-pin connector (flat side up) into the Speakers jack labeled
"Main" on the back of the media center.
3. Insert the telephone-style RJ-45 connector on the other end of the audio input cable into
the Audio INPUT jack on the Acoustimass module. When properly inserted, it locks in
place.
) Note: An antenna is built into the media center power cord; be sure to unwrap the power
cord for the best remote control operation (Figure 11).
) Note: Refer to "Expanding your system to other rooms" on page 32 for information on con-
necting a second room.
Figure 11
Acoustimass connection to
media center
Media center connector panel
Note: When fully inserted into the jack, the connector
locks in place. To release the cable connector, press
the tab.
A
CAUTION: Do not place strain on the audio input cable, especially on the connection to the
Acoustimass module. Excessive strain on the cable may cause damage to the connection at
the Acoustimass module. When disconnecting the cable from the Acoustimass module, be
sure to press the tab on the connector.
15