Connecting The Acoustimass Module To The Media Center - Bose Lifestyle DVD Installation Manual

Connecting the Acoustimass ®module to the media center
Connect the Acoustimass module to the media center with the audio input cable (Figure 10).
Note: Be sure that each connector is fully inserted into each jack.
1. Plug the small black multi-pin connector (flat side facing up) into the SPEAKER ZONES
jack labeled "1" on the back of the media center.
2. Insert the telephone-style RJ-45 connector on the other end of the audio input cable into
the AUDIO INPUT jack on the Acoustimass module. Align the connector at the angle
shown in Figure 10. When properly connected, it should lock in place.
Note: Refer to "Setting up a second listening zone" on page 23 for information on connecting
a second zone.
Figure 10
Acoustimass connection to
media center
Acoustimass module
connector panel
Audio input cable
Note: Press tab to release cable connector.
When fully inserted into the jack, the connector
locks in place.
_IL CAUTION: Do not place strain on the audio input cable, especially on the connection to the
Acoustimass module. Placing excessive strain on the cable may cause damage to the cable
connection at the Acoustimass module. When disconnecting the cable from the Acoustimass
module, be sure to press the tab on the connector.
AM 259777 Rev.O0 PDF August 14, 2001 13