Idrac Settings Utility - Dell PowerEdge M630p Owner's Manual

Option Description
When enabled, In-System Characterization (ISC) executes during POST upon detecting relevant changes in
system configuration to optimize system power and performance. ISC takes about 20 seconds to execute, and
system reset is needed for ISC results to be applied. The Enabled - No Reboot option executes ISC and
continues without applying ISC results until the next time system reset occurs. The Enabled option executes ISC
and forces an immediate system reset so that ISC results can be applied. It takes the system longer to be ready
due to the forced system reset. When disabled, ISC does not execute.
Related References
Miscellaneous Settings on page 46
Related tasks
Viewing Miscellaneous Settings

iDRAC Settings utility

The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI. You can enable or disable various
iDRAC parameters by using the iDRAC settings utility.
NOTE: Accessing some of the features on the iDRAC settings utility needs the iDRAC Enterprise License upgrade.
For more information about using iDRAC, see Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanuals.
Related concepts
Device Settings on page 48
Related References
System BIOS on page 25
Related tasks
Entering the iDRAC Settings utility
Changing the thermal settings
Entering the iDRAC Settings utility
Steps
1. Turn on or restart the managed system.
2. Press F2 during Power-on Self-test (POST).
3. On the System Setup Main Menu page, click iDRAC Settings.
The iDRAC Settings screen is displayed.
Related References
iDRAC Settings utility on page 47
Changing the thermal settings
The iDRAC settings utility enables you to select and customize the thermal control settings for your system.
1. Click iDRAC Settings > Thermal.
2. Under SYSTEM THERMAL PROFILE > Thermal Profile, select one of the following options:
• Default Thermal Profile Settings
• Maximum Performance (Performance Optimized)
NOTE: The default setting for In-System Characterization is subject to change in future BIOS
releases.
on page 46
on page 47
on page 47
Pre-operating system management applications 47