Dell PowerEdge M630p Owner's Manual page 108

1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Remove the hard drive or SSD. .
4. Remove the hard drive or SSD backplane.
Steps
1. Align the retention screws on the hard drive or SSD backplane cable connector with the screw holes on the system board connector.
2. Tighten the two retention screws to secure the backplane cable connector on the system board.
3. Install the hard drive or SSD cage.
4. Align the guides on the hard drive or SSD backplane with the guide pins on the hard drive or SSD cage.
5. Pressing the release latches, lower the hard drive or SSD backplane into the system until it is firmly seated, and the latches engage
with the chassis.
Figure 58. Installing the 2.5-inch (x2) hard drive or SSD backplane
108 Installing and removing server module components