Table of Contents
Advertisement
Figure 10. Installing a server module
a. PCIe label on server module
NOTE:
This label indicates that the server module is configured specifically for the VRTX enclosure.
b. VRTX enclosure
c. server module
Next steps
1. Turn on the server module.
2. If applicable, install the front bezel of the PowerEdge VRTX enclosure.
Related References
Safety instructions
on page 51
Related tasks
Removing a server module
System cover
The system cover protects the innyards of the server, while also help maintaining proper flow of air inside the server. The removal of the
system cover also actuate the intrusion switch and this aids in maintaining system security.
Removing the system cover
Prerequisites
1. Follow the safety guidelines listed in safety instructions section.
2. Turn off the server module by using CMC.
3. Remove the server module from the enclosure.
4. Install the I/O connector cover.
Steps
1. Press the release button and slide the cover toward the back of the server module.
56
Installing and removing server module components
on page 52
Advertisement
Table of Contents
Troubleshooting
