Start Up
Flushing a New Sprayer
This sprayer arrives from the factory with a
small amount of test fluid in the system. It is
important that you flush this fluid from the
sprayer before using it for the first time.
1.
Perform Pressure Relief Procedure,
page 12.
2.
Make certain ON/OFF Switch is OFF.
3.
Place Suction Tube with Drain Tube in
grounded metal pail partially filled with
warm soapy water. See Grounding,
page 10.
14
4.
Turn Prime/Spray Valve down to PRIME
position.
5.
Plug power supply cord into a properly
grounded electrical outlet.
ti24640a
ti24651a
3A7656C