JUKI PS-800-8045 Instruction Manual page 63

❹
❷
Parallel
6-2-4-3. Position of the knife pressure adjust-
Adjust the position of the knife pressure adjustment
screw so that it does not protrude the end face of the
counter knife.
❶
6-2-4-4. Position of the knife pressure adjust-
❶
Temporarily tighten setscrew ❸ to allow the counter
knife to be pressed against two portions ❹ of mount-
ing base ❷ .
Loosen connection screw ❶ . Turn the counter knife
shaft by hand to adjust so that the counter knife is
almost in parallel with the moving knife.
Under the operation panel manual mode, press the
OUT1 (before the port change) / OUT9 (after the
port change) button to place it in the ON state. Bring
the moving knife closer to the counter knife. Adjust
the parallelism between them.
❸
– 60 –
ment screw of the counter knife
ment screw of the counter knife
Under the operation panel manual mode,
press the "OUT1 (before the port change)
/ OUT9 (after the port change)" button to
place it in the ON state. Bring the moving
knife closer to the counter knife. Adjust
the parallelism between them.