JUKI PS-800-8045 Instruction Manual page 39

Classifi-
cation of No. Parameter name
parameters
Speed P174 Machine head 2 speed
parameter (mm/s)
P175 Machine head 3 speed
(mm/s)
P178 Continuous inching speed
P773 Number of revolutions in
the reverse direction (r/
min)
P774 Number of stitches to be
sewn at a limited speed at
the end of sewing
P775 Limited sewing speed to
be employed at the end of
sewing
Clamp P22 Prohibition of sewing
during lifting of the clamp
setting
P25 Thread clamp starting
angle at the beginning of
sewing
P26 Thread clamp ending angle
at the beginning of sewing
P27 Thread clamp starting an-
gle during thread trimming
P28 Thread clamp ending angle
during thread trimming
P781 Whether or not the clamp
is required during travel
P743 Delay in opening of the
double clamp (ms)
P744 Delay in lowering of the
double clamp (ms)
Bobbin P29 Bobbin winder status
winder
setting
P30 Winding speed (r/min)
(limited to
the 6045
P31 Bobbin winding time setting
model)
(s)
Reset P36 Clamp at the time of reset-
ting
setting
P264 Clamp is opened after
manual resetting
P38 Return-to-origin method
P39 Return-to-origin speed
(mm/min)
P756- Output I/O setting before
resetting
P761
P762-
P797
Standard
Range
value
0 to 2000 0
0 to 2000 0
Reduce / mini- Reduce
mum / normal
0 to 3000 0
0 to 30 0
100 to 1800 0
Yes/No Yes
1 to 990 10
1 to 990 10
1 to 990 15
1 to 990 180
Yes/No No
0 to 5000 0
0 to 5000 0
Allowed / pro- Allowed
hibited
100 to 4500 2200
1 to 63000 200
Yes/No No
Yes/No Yes
XY simul- XY simul-
taneous / X taneous
preference / Y
preference
100 to 60000 15000
OUT1 to OUT6 Not set
/ Not set
High level / low High level
level
– 36 –
Meaning of parameter and comment
XY axes speed when using a laser
knife
XY axes speed when using a laser
knife
Travel speed during pattern creation
Reverse feed stitching speed
Setting of the number of stitch from
which the sewing speed is limited at
the end of sewing a pattern
This parameter is used in combination
with P774 to obtain the specific limited
speed value.
Prohibition of sewing during lifting of
the cassette clamp
Thread clamp ON angle at the begin-
ning of sewing
Thread clamp OFF angle at the begin-
ning of sewing
Thread clamp starting angle during
thread trimming
Thread clamp ending angle during
thread trimming
Bobbin winder
Default state
Bobbin winding speed
Time setting of bobbin winding
Cassette clamp comes down when
returning to origin
Cassette clamp goes up when returning
to origin by pressing the reset button
"xy simultaneous" means that the x and
y axes are simultaneously reset to their
origins. "x preference" means that the
x axis is firstly reset to the origin, and
"y preference" means that the y axis is
firstly reset to the origin.
x, y axes speed during resetting to the
origin
Setting of IO before resetting