Porsche 911 Manual page 82

Child Restraint Systems (Child Seats)
A
The retaining lugs A of the ISOFIX child restraint
system anchorage points are located between the
B
backrest and seat surface of the passenger seat.
C
1. Deactivate the passenger airbag with the emer-
gency key in the glove box OFF.
D
The PASSENGER AIR BAG OFF warning light on
E
the overhead console must come on.
2. Adjust the passenger seat to the rearmost upper
F
position.
> Please refer to chapter "Adjusting the seat"
G
on page 203.
H
3. Secure the child restraint system to retaining
I
lugs A as described in the instruction manual for
the child restraint system.
J
4. Pull the child restraint system to check that both
K
anchorage points are properly engaged.
5. Adjust the backrest angle of the passenger seat
L
so that there is solid contact between the pas-
M
senger seat and child restraint system.
6. If the rear seat is occupied, make sure that there
N
is sufficient clearance between the child or child
O
seat or passenger and the front seat. Adjust the
front seat in front of the child or child seat or
P
passenger as far forward and as high as possible,
Q
and the seat backrest as steeply as possible.
R
S
T
U
V
W
X
Y
Z
80
Installing child restraint system with support leg on
passenger seat
Fig. 42: Installing child restraint system with support leg
1. Install the child restraint system with ISOFIX an-
chorage system correctly with the retaining lug
A.
> Please refer to chapter "ISOFIX anchorage
system on passenger seat" on page 79.
2. Position the support leg in accordance with the
child restraint system manufacturer's
instructions.
3. Ensure that the child restraint system is posi-
tioned flush against the passenger seat.
Installing child restraint system on the rear seats
Fig. 43: ISOFIX anchorage system on rear seats
The retaining lugs A of the ISOFIX anchorage system
for the child restraint system are located behind the
backrest lower sections.
1. First detach the backrest lower section at the top
centre (Velcro strap), disengage from the retain-
ing lugs A and remove.
2. Secure the child restraint system to retaining
lugs A as described in the instruction manual for
the child restraint system.
3. Pull the child restraint system to check that both
anchorage points are properly engaged.
4. Make sure that there is solid contact between
the rear seat and child restraint system.
5. Make sure that there is sufficient clearance be-
tween the child or child seat and the front seat.
Adjust the front seat in front of the child or child
seat as far forward and as high as possible, and
the seat backrest as steeply as possible.