Table of Contents
Advertisement
3. Locate the straight barb hose connectors in loose
parts and install the connector to the inlet and outlet
openings of the rinse-tank pump
1. Rinse-tank pump
4. Locate the wire harness of the rinse-tank pump.
5. Locate the connector labeled R
wire harness at the rear of the tank.
6. Connect the rinse-tank pump to the main wire harness.
6
Installing the Hoses and Filter
Parts needed for this procedure:
2
Hose (rinse nozzle)
10
Hose clamp
1
Tee fitting
1
Hose (supply)
1
Filter assembly
1
Hose (rinse tank)
1
Convoluted conduit
2
Cable tie
Install the Rinse Nozzle Hoses
Note: Lightly lubricate the barbed end of a hose fitting with
a non-petroleum based lubricant, such as vegetable oil, to
ease the process of installation.
1. Locate a rinse nozzle hose in loose parts.
Note: There are 3 hoses of the same length, 1 is for
the rinse-tank pump supply hose, and 2 are the rinse
nozzle hoses.
2. Assemble a hose clamp onto the end of each hose
(Figure
21).
(Figure
20).
1
2
2
G014290
Figure 20
2. Straight connector
P
on the main
INSE
UMP
1
G014291
1. Rinse-nozzle barb
2. Rinse-nozzle hose
3. Install a hose over the barb of the rinse nozzle
21).
Repeat the procedure for the other rinse nozzle barb.
4. Slide a hose clamp over the barb and tighten to secure.
Repeat this procedure for the other rinse nozzle.
Installing the Tee Fitting
1. Locate the tee fitting in loose parts.
2. Install the tee fitting to the open ends of the rinse
nozzle hoses installed previously as shown in
3. Slide the hose clamps over the barb and tighten to
secure.
Installing the Supply Hose
1. Locate the long supply hose in loose parts.
2. Measure 17.8 cm (7 inches) from the end of the hose.
3. Cut the hose at that mark.
4. Install a hose clamp over each end of the longer hose.
5. Install the hose to the open end of the tee fitting
installed previously
9
1
2
4
2
3
Figure 21
3. Hose clamp
4. Tee fitting
(Figure
22).
(Figure
Figure
21.
Advertisement
Table of Contents
