Table of Contents
Advertisement
Installing the Rocker Switch into the
Dash
1. Remove the plug for the rinse tank switch from the
dash panel
(Figure 29
Note: It is the second plug to the right of the ignition
key.
Figure 29
2015 and Before Machines
1. Plug
2. Connector for rinse tank
(main wire harness)
or
Figure
30).
3. 3-position switch (with
indicator light)
2016 and After Machines
1. Plug
2. Connector for rinse tank
(main wire harness)
2. Working from underneath the dash panel, remove the
cable tie that secures the 8-socket connector labeled
R
T
from the main harness.
INSE
ANK
3. Route the 8-socket connector toward the open hole in
the dash
(Figure 29
4. Connect the 3-position switch into the 8-socket
connector through the dash panel
30).
5. Insert the 3-position switch into the opening in the
dash panel until the latch of the switch snap securely
into the dash
(Figure 29
13
Figure 30
3. 3-position switch (without
indicator light)
or
Figure
30).
(Figure 29
and
Figure
30).
or
Figure
Advertisement
Table of Contents
