Table of Contents
Advertisement
Installing the Rinse Tank
1. Install the rinse tank as shown in
1. Rinse tank
2. Install the rinse-tank straps to the hardware installed
previously on the rear strap tank straps.
Note: The wire tank lid stop needs to be installed over
the left rinse-tank strap and the main tank strap; then
secured with the locknut.
1
6
Figure 10
1. Bolt
2. Tank lid stop wire
3. Locknut
3. Secure the rinse-tank straps to the rear tank strap with
2 locknuts.
4. Secure the rinse-tank straps to the mounting rail using
2 bolts, 4 washers, and 2 locknuts.
Note: Carefully tighten the fasteners. The rinse tank
must be seated and secure but the straps should not
deform or warp the tank.
5. Replace the supply hose at the rear of the tank and
secure it with the retaining fork removed previously.
Figure
9.
G014233
Figure 9
2
3
5
6
3
G014234
4. Carriage bolt
5. Rinse-tank strap
6. Washer
Note: Once the rinse tank has been initially filled, check
and tighten the rinse-tank strap fasteners , if necessary, as the
weight of the liquid can further seat the tank against the frame.
4
1
Installing the Rinse Nozzles
Parts needed for this procedure:
2
Rinse nozzle
2
Bulkhead fitting
2
Shoulder bolt
2
Bushing
2
Rinse vane
2
Gasket
2
Plastic flange nut
2
90° fitting
Drilling the Main Tank
1. Open the tank lid and remove the strainer basket.
2. Locate the 2 drill marks in the main tank
4
1. Drill marks
3. Move to the drill mark behind the tank lid.
Note: Place a receptacle inside the tank, below the
areas to be drilled, to catch any debris created during
the cutting.
Important: Debris left inside a tank could clog
and damage the spray system during operation.
4. Use a 4.5 cm (1-3/4 inch) hole saw to drill a hole at
the drill mark
6
1
G014244
Figure 11
(Figure
12).
(Figure
11).
Advertisement
Table of Contents
