Table of Contents
Advertisement
7
Installing the Delay Timer and
Dash Switch
Parts needed for this procedure:
1
Delay timer
1
Fuse (40 A)
3-position switch (with indicator light—2015 models
1
and before machines)
3-position switch (without indicator light—2016
1
models and after machines)
1
Relay
1
Power relay
2
Screw #10–24
Installing the Delay Timer, Relays, and
Fuse
1. Raise the operator seat to access the electronic
components under the seat.
2. For 2015 and before machines, perform the following:
Note: You do not need the delay time for 2016 and
after machines.
A. Install the delay timer to the location shown in
Figure 26
or
Figure
electrical panel.
B. Connect the timer to the 2-socket connector
labeled delay timer of the machine wire harness
(Figure 26
or
Figure
27with the locknut from the
27).
1
8
7
2014 and Before Machines
1. Electrical panel
2. Locknut
3. Delay timer
4. Delay timer connector
(machine wire harness)
5. Main wire harness
11
3
2
4
G0151 13
6
Figure 26
6. Fuse block
7. Fuse (40 A)
8. Relay
9. Power relay
5
9
Advertisement
Table of Contents
