Mounting The Wall Mounting Bracket - SMA Sunny Boy 6000TL‑US Installation Manual

4 Mounting
4.2.2 Mounting the Wall Mounting Bracket
1. Position the wall mounting bracket at the installation location. If possible, select eye level.
2. Align the wall mounting bracket with a spirit level. The bottom end of the wall mounting bracket
reaches approximately to the bottom corner of the inverter.
3.
Electric shock due to damaged electric cables
Electric cables may be located behind the installation points which can be damaged when
mounting the inverter.
• Ensure that no electric cables are located behind the installation points.
4. Use the wall mounting bracket as a template. Mark at least 3 holes in the horizontal or vertical
position of the wall mounting bracket (see Section 4.2.1 "Possibilities for Mounting the Wall
Mounting Bracket", page 23).
5. Remove the wall mounting bracket and drill the holes at the markings.
The diameter of the drill holes must correspond to the fasteners that you use for mounting
the inverter.
Mounting on a concrete wall
• The hole diameter must be the same as the outer diameter of the screw anchors.
• Insert suitable screw anchors into the drill holes.
Mounting on a wall with wooden support posts
The hole diameter must correspond to the screw diameter used. The screws should be
stainless steel. The diameter of the screws must correspond to the diameter of the holes
in the wall mounting bracket. The screws must be long enough to reach a depth in the
1
wall of 1
6. Insert the screws into the drill holes through the holes in the wall mounting bracket.
7. Tighten the screws clockwise until the wall mounting bracket hangs securely on the wall.
24 SB6-11TL-US-IA-en-13
⁄ in.
2
SMA America, LLC
Installation Manual