Headset Mode - Comdial DX-80TM User Manual

4.2. To program a feature code, press [ftr].
4.2.1. Press the
4.2.2. Input the feature code
5. Continue programming other Flexible Feature Buttons or lift/replace
the handset to exit this programming.

Headset Mode

All Digital Speakerphones have a standard 2.5 millimeter headset jack.
When Headset Mode is selected (either by pressing a preprogrammed
headset feature key or dialing the Headset Mode code), the
used to activate/deactivate the headset.
When you press the
status changes to an off-hook condition. When you press the
again, the extension status returns to idle, disconnecting any call in
progress.
Operation – Activate Headset Mode
1. While the telephone is idle, press
Feature button designated as HEADSET MODE (if available). The
display indicates the new status:
Operation – Deactivate Headset Mode
1. While the telephone is idle, press
Feature button programmed with the Headset Mode code. The display
indicates the new status:
Operation – Use the Headset to Place a Call
1. While the telephone is idle, press
button. The
active. You hear Intercom dial tone, outside line dial tone, or Intercom
ring-back tone, depending on the function invoked.
2. Press
Page 42
FTR CODE:_
bksp save chg
!
then press [save].
button, Headset Mode active and the extension
HEADSET ENABLED
HEADSET DISABLED
button LED flashes to indicate that the headset is
again to disconnect the current call.
button.
6/
(for CID Table review) and
!9/
!*9/
, a DSS button, or outside line
!9/
or press the Flexible
or press the Flexible
P7292 DETUG 09/01
button is
button