Attaching Or Detaching The Tape Feeder Onto A Mounter - JUKI AF05 Instruction Manual

ATF Instruction Manual

2.5 Attaching or Detaching the Tape Feeder onto a Mounter

1) Check to see if there is no foreign substance such as an element on the fixed side
of the tape feeder or upper surface of the mounter bank.
Fixing plate
Mounter (bank)
Check to see if there is no foreign
substance such as an element on the
upper surface of the bank.
2) Pinch the grip section with one hand and lay another hand on the tail guide to
support it.
3) Place the fixed side of the tape feeder on the feeder bank.
4) Pull the release lever toward your side. (See Figure 2.5.2.)
5) Slide the tape feeder in the fixing direction, and push the X-axis reference pin "A"
against the positioning hole on the fixing plate of the bank, the fixing pin against the
U-groove of the fixing plate B, and the lock holder and the plunger plate against the
lock shaft V-groove. (See Figure 2.5.1.)
6) Push the release lever to fix the tape feeder. Check to see if the feeder is
securely fixed on the mounter with following the procedure described below.
Detaching
Release lever
7) To detach the tape feeder, pull the release lever toward your side, and grasp the
grip section in the detaching direction to detach the tape feeder.
CAUTION
Positioning hole of
the fixing plate
U-groove of the
fixing plate B
Lock shaft V-groove
Figure 2.5.1
Fixing
Fixed condition (The lever
is set in the same manner
as the adjacent lever is.)
Figure 2.5.2
Fixing
取付け
Figure 2.5.3
Check to see there is no foreign substance such as a component on the
bottom side of the feeder and the top surface of the bank.
X-axis reference pin A
Lock holder
plunger plate
Not fixed condition (The lever
is not set in the same manner
as the adjacent lever is.)
Detaching
取外し
15
Fixing pin