Rear Panels - ZyXEL Communications FMG3010-R20A User Manual

Buttons
Figure 7 FMG3015-R20A Rear Panel
The following table describes the items on the panels.
Table 4 Panel Ports and Buttons
LABEL
LED
Reset
1.4.2.1 The LED Button
Press the LED button for more than two seconds to turn on/off the LEDs.
1.4.2.2 The RESET Button
If you forget your password or cannot access the Web Configurator, you will need to use the RESET
button to reload the factory-default configuration file. This means that you will lose all configurations
that you had previously. The password will be reset to the factory default (see the device label), and the
LAN IP address will be "192.168.1.1".
Make sure the POWER LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for more than five seconds
2
or until the POWER LED begins to blink and then release it. When the POWER LED begins to blink, the
defaults have been restored and the device restarts.

1.4.3 Rear Panels

The fiber connector is located on the rear panel. See the Quick Start Guide for how to do the hardware
installation.
Figure 8 FMG3010/3015-R20A Rear Panel
Chapter 1 Introducing the FMG
DESCRIPTION
Press the button for more than two seconds to turn on or off the LEDs.
Press the button in for more than five seconds (or until the PWR LED starts to blink), then release it to
return the FMG to the factory defaults.
FMG3010/3015-R20A User's Guide
13