Vermont Castings Radiance RUVS40 Homeowner's Installation And Operating Manual page 13

Fig. 17 Remove the valve cover plate.
Fig. 18 Flexible gas line connection.
On/Off
Pilot
Control
Adjustment
Knob
Screw
OFF
Pressure Tap
Fig. 19 The gas control valve includes a captured screw-
type pressure test point. A pressure test point upstream from
the control valve is not required.
OFF
ST172
OFF
ST173
Regulator
Piezo
Ignitor
HV100
Vermont Castings Radiance
Install the Logs
Install the logs in sequence as shown below. The log
set includes six sections: the rear log, left and right
middle logs, left and right ember logs, and an upper
log. There is also a bag of lava rocks which simulate
charcoal and embers.
1. Install the rear log (#1, Fig. 20) by engaging holes
on its bottom surface with pins on the sheet-metal
shelf at the back of the firebox.
2. Install the left and right middle logs (#2 and #3, Fig.
20) by engaging holes on their bottom surfaces with
pins on the burner brackets.
2
Fig. 20 Install rear and middle logs.
3. Push the burner assembly fully to the rear. There
should be a gap of about 13/16" between the front of
the burner and the inside front wall of the firebox.
Place the two front ember log sections (#4 and 5,
Fig. 21) in the slot at the front of the firebox, just in
front of the burner.
5
Fig. 21 Install the front ember logs.
1
Brackets
ST142
4
ST143
3
13