Table of Contents
Advertisement
INSTALLER / CONSUMER
SAFETY INFORMATION
PLEASE READ THIS MANUAL
BEFORE INSTALLING AND
USING APPLIANCE.
WARNING!
IF THE INFORMATION IN THIS
MANUAL IS NOT FOLLOWED
EXACTLY, A FIRE OR EXPLOSION
MAY RESULT CAUSING
PROPERTY DAMAGE,
PERSONAL INJURY OR LOSS OF
LIFE.
— Do not store or use gasoline
or other flammable vapors and
liquids in the vicinity of this or
any other appliance.
— WHAT TO DO IF YOU SMELL
GAS:
•
Do not try to light any appliance.
•
Do not touch any electric switch; do
not use any phone in your building.
•
Immediately call your gas supplier
from your neighbor's phone. Follow
the gas supplier's instructions.
•
If you cannot reach your gas sup-
plier, call the fire department.
Installation and service must be per-
formed by a qualified installer, service
agency or the gas supplier.
This appliance may be installed in
an after market permanently located
manufactured (mobile) home where not
prohibited by local codes.
This appliance is only for use with the
type of gas indicated on the rating plate.
This appliance is not convertible for use
with other gases unless a certified kit is
used.
Radiance Natural Vent
Gas Heater
Model RNVOD: 3233 thru 3236,
3340 thru 3349, 3355, 3356
Homeowner's Installation
and Operating Manual
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
4409
Radiance
cover
4/01
C E RT I F I E D
20004409 4/07 Rev. 17
Advertisement
Table of Contents
Related Manuals for Vermont Castings RNVOD 3340
Summary of Contents for Vermont Castings RNVOD 3340
-
Page 1: Safety Information
INSTALLER / CONSUMER SAFETY INFORMATION PLEASE READ THIS MANUAL BEFORE INSTALLING AND USING APPLIANCE. Radiance Natural Vent WARNING! Gas Heater IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED Model RNVOD: 3233 thru 3236, EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING 3340 thru 3349, 3355, 3356 PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF... -
Page 2: Table Of Contents
Table of Contents PLEASE READ THE INSTALLATION & OPERATING INSTRUCTIONS BEFORE USING APPLIANCE. Thank you and congratulations on your purchase of a Vermont Castings stove. IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible fire hazard and will void the warranty. -
Page 3: Installation & Operating Instructions
Radiance Natural Vent Gas Heater Installation & Operating Instructions The Radiance Direct Natural Vent Room Heater, Model Nos. WARNING: Operation of this heater when not connected 3233 thru 3236, 3340 thru 3349, 3355 and 3356 are vented to a properly installed and maintained venting system can gas appliances listed to the ANSI standard Z21.88-2005 and result in carbon monoxide (CO) poisoning and possible CSA-2.33-2005 for Vented Room Heaters, and CSA 2.17-M91,... -
Page 4: Stove Dimensions
Radiance Natural Vent Gas Heater Stove Dimensions 4" Inner Dia. 14���" Refer to Page 5 for Flue (102 mm) (378 mm) Collar Centerline Dimen- sions 4���" (114 mm) 29���" (756 mm) R A D I A N C E 28" (711 mm) Supply Inlet... -
Page 5: Corner Installation
Radiance Natural Vent Gas Heater Corner Installation: Alcove Minimum Dimensions Minimum Clearance and Flue Centerline 42" (1067 mm) 4" (102 mm) 6" 6" (152 mm) (152 mm) ST130a ST129b Fig. 5 The Radiance Natural Vent Stove is approved for ST130a Fig. -
Page 6: Gas Specifications
Radiance Natural Vent Gas Heater Warning: WARNING: Improper installation, adjustment, alteration, service or maintenance can cause in- • Always maintain required clearances jury or property damage. Refer to this manual for (air spaces) to nearby combustibles to correct installation and operational procedures. prevent fire hazard. -
Page 7: Vent Layout And Height Requirements
Radiance Natural Vent Gas Heater Vent Layout and Height Requirements Venting for a Radiance can rise vertically through the home, or can pass through an exterior wall and rise along the outside of the home. Some codes require that a Type B vent system rising on the outside of the home be enclosed in a chase. -
Page 8: Assembly Procedures
Radiance Natural Vent Gas Heater Assembly Procedures Tools Required CAUTION: To prevent valve tubing from being crushed or damaged, make sure to rest valve on • Phillips screwdriver (stub) • power drill wooden pallet. • utility knife • reciprocating saw •... - Page 9 Radiance Natural Vent Gas Heater • 1. The fan kit includes a Blower Assembly and a Rheo- Remove retaining nut from shaft of rheostat. (if stat Assembly, connected by a cable. (Fig. 10) The preinstalled) Blower Assembly mounts to the bottom rear of the •...
- Page 10 Radiance Natural Vent Gas Heater Rear Shroud Cover Plate Rear Shroud Assembly ST713 ST371 Fig. 15 Remove rear shroud. Fig. 13 Attach rear shroud cover plate to the rear shroud. 5. Attach the fan assembly to the fan bracket provided in the finish bag.
- Page 11 Radiance Natural Vent Gas Heater 11. Slide shroud assembly over the sides and fasten the Snapstat Bracket four screws loosened earlier. Snapstat Module 12. The rheostat control switch attaches to the left side Pinch Grommet to of the valve bracket at the front of the stove. (Fig. 20) Remove •...
-
Page 12: Venting System Assembly
Radiance Natural Vent Gas Heater Attach the first section of venting to the B-vent adapter. Venting System Assembly Depending on the length of the individual venting Adjust the leg levelers as needed. They should not sections and the lengths of the decorative pipe, you extend any further from the leg than necessary. -
Page 13: Connect Gas Supply Line
Radiance Natural Vent Gas Heater Burner Information Connect the Gas Supply Line The appliance must only use the gas specified on the Check the Rating Plate attached by a steel cable to the rating plate, unless converted using a Fuel Conversion firebox, to confirm that you have the appropriate firebox Kit. -
Page 14: Thermostat Connection (Optional)
Radiance Natural Vent Gas Heater Install Rear Bracket and Log Set 1. Remove the logs from their packaging, and inspect each piece for damage. DO NOT INSTALL DAM- AGED LOGS. Rear Log Bracket ST228 Fig. 26 Attach switch wires to valve. Thermostat Connection (optional) Use only a thermostat rated for 500 - 750 millivolts. - Page 15 Radiance Natural Vent Gas Heater Figure 28 Right Log Right Rear Log Left Rear Log Figure 29 LG156 Right Bracket Decorative Left Bracket Grate LG156 Radiance logs 4/23/01 djt LG155 Log rests on Lava Rock decorative grate Figure 30 Left Rear Right Rear LG155 Radiance logs...
-
Page 16: Operation
Radiance Natural Vent Gas Heater Operation Operable Doors The Radiance is shipped with the operable door front. The stove may be operated with the doors either open or closed. To open the front doors, insert the handle into the door latch stub and turn it to the right and up. (Fig. 31) When not in use, the handle may be stored in the handle holder on the right side of the rear shroud. - Page 17 Radiance Natural Vent Gas Heater Lighting and Operating Instructions FOR YOUR SAFETY READ BEFORE LIGHTING WARNING:If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This heater has a pilot which must be lit manu- •...
-
Page 18: Troubleshooting - Honeywell #8420 Gas Control System
Radiance Natural Vent Gas Heater Troubleshooting / Honeywell #8420 Gas Control System NOTE: Before troubleshooting the gas control system, be sure the external gas shutoff is in the “ON” position. WARNING: REMOVE THE GLASS PANEL BEFORE PERFORMING ANY GAS CONTROL SERVICE WORK. SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION... -
Page 19: Fuel Conversion Instructions
Radiance Natural Vent Gas Heater Fuel Conversion Instructions 6. Remove the right and left log bracket assembly by WARNING! This conversion kit shall be installed unfastening the two screws which hold the burner in by a qualified service agency in accordance with place. -
Page 20: Air Shutter
Radiance Natural Vent Gas Heater Pilot Orifice Conversion 2. Remove the screw from center of Hi-Lo knob with small screwdriver turning counterclockwise. (Fig. 40) 1. Locate pilot. (Fig. 38) 3. Insert blue painted screw when converting to natural 2. Replace pilot orifice. gas and red painted screw when converting to LP. - Page 21 Radiance Natural Vent Gas Heater 4. Replace burner. Slide the burner in at an angle with left side lower than the right side. Slide the left side onto the injectors, making sure the burner leg remains at a 90° angle to the base. Lower the right hand side down in to place.
-
Page 22: Maintenance
Radiance Natural Vent Gas Heater Maintenance Your Radiance Gas Heater will provide years of service CAUTION with minimal upkeep. The following procedures will help ensure that your stove continues to function properly. TURN THE PILOT OFF BEFORE PAINTING. ALLOW THE HEATER TO COOL COMPLETELY Annual System Inspection BEFORE PAINTING Have the entire heater and venting system inspected... -
Page 23: Gasket Replacement
Do not use your stove if the flame pattern differs from any remaining cement or bits of gasket. that shown here. Contact your Vermont Castings dealer 2. Determine the correct length of gasket by laying it or a qualified technician for help. -
Page 24: Wiring Diagrams
Radiance Natural Vent Gas Heater On/Off Switch Wiring POWER CORD TP/TH Chassis Black Ground ST124b Thermostat Thermostat (Optional) (Optional) Optional Thermostat Millivolt Wiring Gas Valve FAN JUNCTION BOX St124b on/off/switch TP/TH Strain Relief wiring ON / OFF 1/11/00 djt Rheostat Black ST124c Snapstat... -
Page 25: Replacement Parts
Radiance Natural Vent Gas Heater 15a,b 9a,b 8a,b,c,d 7a,b 18a,b 26a,b, 44a,b CFM Corporation reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. Radiance Natural Vent Gas Heater (RNVOD) 3456 Stardance parts 10/5/00 djt... - Page 26 Radiance Natural Vent Gas Heater Radiance Natural Vent Gas Heater (RNVOD) Models: 3233 thru 3236, 3340 thru 3349, 3355, 3356 (continued) Ref. Description RNVOD Log Set -RDVOD/RNVOD 20004184 Right Rear Log RDNOD/RNVOD 20004185 Left Rear Log RDVOD/RNVOD 20004186 Right Log RDVOD/RNVOD 20004187 Manifold Assembly 20003739...
- Page 27 Radiance Natural Vent Gas Heater Radiance Natural Vent Gas Heater (RNVOD) Models: 3233 thru 3236, 3340 thru 3349, 3355, 3356 (continued) Ref. Description RNVOD Bracket, Back Log - RDVOD 20003577 Grille, RVF 1301192 Screen, RVF 1601933 33a. Vent Switch Wire Assembly - RNV40 Serial #’s up to #1456 (RNVODRN), #1943 (RNVODRP) 30000108 33b.
-
Page 28: Optional Accessories
Radiance Natural Vent Gas Heater Optional Accessories Fan Kits Screen Kit FK26 Fan An optional screen, R40SK, is available for use with the operable doors to allow the doors to be left in the open The FK26 fan kit helps distribute heated air from within position. - Page 29 Radiance Natural Vent Gas Heater 20004409...
-
Page 30: Warranty
Radiance Natural Vent Gas Heater LIMITED LIFETIME WARRANTY PRODUCT COVERED BY THIS WARRANTY All Vermont Castings gas stoves, gas inserts, and gas fireplaces, and all Majestic brand gas fireplaces equipped with an Insta-Flame Ceramic Burner, or standard steel tube burner. BASIC WARRANTY •... - Page 31 PRODUIT COUVERT PAR LA PRÉSENTE GARANTIE L’ensemble des cuisinières à gaz, des poêles encastrables et des foyers à gaz Vermont Castings, ainsi que l’ensemble des foyers à gaz de marque Majestic équipés d’un brûleur en céramique Insta-Flame ou d’un brûleur en acier standard.
-
Page 32: Energuide
Efficiency Ratings Model EnerGuide Ratings Fireplace Efficiency (%) RNVODRN 55.9 RNVODRP 55.9 CFM Corporation 2695 Meadowvale Blvd. • Mississauga, Ontario, Canada L5N 8A3 800-668-5323 • www.cfmcorp.com...