Vermont Castings Radiance RUVS40 Homeowner's Installation And Operating Manual page 10

Vermont Castings Radiance
Install Optional Fan, #2767/FK26
Install the fan kit before the stove is connected to the
gas line.
The fan consists of a blower assembly and a
rheostat switch that are connected by a wire harness.
The blower attaches to brackets at the bottom of the
rear shroud. The rheostat installs within the remote
switch box, at the top left rear corner.
The fan kit includes a 'snapstat', a temperature-
sensing switch which will be mounted to the blower
duct just below the top plate of the stove. The snapstat
automatically turns the fan on or off at approximately
109 F.
The rheostat provides a range of fan speed settings
from OFF (which overrides the snapstat function) to
high.
Kit Contents used with the RUVS40:
• Fan assembly with rheostat and snapstat
• wire tie • control knob
These directions are oriented facing the rear of the
stove. Position the fan underthe rear shroud as shown
in Figure 10.
1. Remove the fan bracket. Remove the four sheet
metal screws (A) to detach the bracket (AA) from the
Rear Shroud. (Fig. 10)
2. Open the left side of Rear Shroud. (Fig. 10)
• Remove the round head phillips screws (B) that
secure the shroud to the side of the stove.
• Remove the sheet metal screw (C) that fastens the
switchbox to the rear shroud.
• Remove the two sheet metal screws (D) that
secure the inner and outer shroud together. Let the
switchbox and wiring hang loosely.
3. Install the Control Switch. (Fig. 10)
• Run the control switch (E) and wire up along the
side between the inner and outer shrouds and through
the slot at the side.
• Attach the switch to the switch box with the retainer
collar and control knob (F).
• Secure the switch box assembly to the rear shroud
with the single sheet metal screw (C).
4. Connect Snapstat leads.
• Disconnect the snapstat module (G) from the leads
inside the snapstat bracket (H).
• Bend open the snapstat bracket (H). Use your
fingers or needle nose pliers to remove the black plastic
grommet from the bracket. Discard the bracket.
• Insert the grommet and wires into the large hole at
the bottom right corner of the inner shroud.
10
• retaining collar
F
C
AA
A
A
H
Fig. 10 Open the rear shroud and install fan control switch.
H
G
ST190
Outer Shroud
Grommet
Fig. 11 Remove the snapstat and grommet from the bracket
and insert the grommet into the inner shroud.
• Feed the snapstat wire leads through the grommet
into the stove interior. Connect the two wires to the two
snapstat extension leads attached to the inner shroud.
E
B
D
B
D
G
ST189
Pinch
grommet
to remove
ST191
Inner Shroud
ST192