Advertisement
4
Keel and Rudder Assembly
9
10
15
18
19
24
26
1. Drill 4mm hole at the dot then
install the Winch Line Guide A
from the inside of the hull then
secure Winch Line Guide A and B
18
together on the deck. Do the
same procedure for the other winch
line guide assembly.
2. Trial fit the keel in place,trim the
contact area if necessary. Make
sure the keel fit into the hull
properly. Secure the keel shaft with
M4 Locknut
by using the
10
furnished 4 way wrench. The keel
can make it inconvenient when
moving the hull around during
assembly.
3. Please use care when placing
the hull on stand as the stabilizer
will contact the Al. Stand B, it will
need slightly to rotate the hull and
let stabilizer go through the display
stand.
4. Install Rudder
in place by
37
securing the Steering Arm
24
Collar
with 3x5mm Screw
19
In this step you will need to connect
26
the Pushrod
by threading the
Z-bend end to steering arm first
then thread the other end to the hull
so you can secure the arm with
collar inside to the rudder shaft as
illustration. Note: the pushrod and
rudder should perpendicular to the
steering arm.
37
15
and
9
.
1-METER
1-METER
1-METER
America's Cup Racing Yacht
America's Cup Racing Yacht
America's Cup Racing Yacht
18
15
10
26
08
24
9
19
37
Advertisement
