THUNDER TIGER 5546 Instruction Manual page 12

7
Servo Tray Assembly
36
1. Locate the die-cut plywood
sheet then use thick CA
36
to assemble the servo tray
as shown.
2. Slightly sand the glue area
inside the hull then apply
enough epoxy to glue servo
tray in the hull. Note the
position will be about 2mm
(5/64") from the edge to the
hatch opening if you see
from the top vertically.Suggest
to use sandpaper to sand the
glue area, this will enhance the
adhesion.
1-METER 1-METER 1-METER
America's Cup Racing Yacht America's Cup Racing Yacht America's Cup Racing Yacht
11
BOW
2mm
STERN