Advertisement
10
Main Sail Rigging
27
30
80
1. Cut 7 pieces Rigging Strings
the lengths as shown for use in this
step.
Jump String A x 1
48"(120cm)
Jump String B x 2
38"(95cm)
Mast String C x 2
52"(130cm)
Mast String D x 2
16"(40cm)
2. Jump String A
Thread the jumper string A from the
second spreader root through the
first spreader tip, head crane, the
first spreader tip and finally back to
the second spreader root. Try to
adjust the string as tight as possible
and make both two Figure Eight
knots at the second spreader root.
3.Jump String B
Make a Figure Eight knot then thread
Jump String B from second spreader
tip to the other side of the third
spreader tip, the other side of fourth
spreader tip then the other side of
the fifth spreader tip. Adjust the
tension and make the same knot.
Do the same procedure for the other
Jump String B.
4. Mast String C
Make a Figure Eight knot then thread
Mast Rigging String C from the first
spreader root through the second
spreader tip, the third, the fourth and
the fifth spreader tip.
Thread the string through the first
hole of String Adjuster
, then the
80
second hole. Next thread through the
Swivel
27
then the third hole. Make
a Bowline knot.
Keep adjuster is about 10cm to the
swivel.
Do the same procedure on the other
Mast Rigging String C.
5. Mast String D
Make a Figure Eight knot then thread
Mast Rigging String D from the fifth
spreader root then do the same way
on the string adjuster and swivel.
Do the same procedure on the other
Mast String D.
into
30
80
1-METER
1-METER
1-METER
America's Cup Racing Yacht
America's Cup Racing Yacht
America's Cup Racing Yacht
4"(100mm)
27
14
A
B
C
D
Advertisement
