Advertisement
14
Radio Installation Ⅱ
2
20
23
27
34
39
43
1. Thread a Metal Clevis
23
pushrod. Attach the clevis to the
servo arm. Adjust the clevis so that
the servo arm and rudder steering
arm are at ninety-degree angle to
the pushrod when servo is in neutral
position. Attach the rudder cover
decal
on the rudder cover
94
then drill (5/64")2mm hole for
antenna to go through. Thread
antenna and attach the cover in
place.
2. Epoxy the Mast Mount
43
Make sure there is no epoxy inside
the mast mount A as the Mast will
install in later. Epoxy the keel in
bottom slot and whole mast mount
is recommended if user would
enhance the performance, however,
the weakness is the keel can not be
removed.
3. Thread one end of the Jib Sail
Control String to the servo drum.
Make a Figure Eight knot in the
drum. Turn on the radio and make
sure the control stick is full down
then wind the string for two turns in
the drum then place the drum on the
winch servo.
4. Tie a Bowline knot to the Swivel
on the other end of the control
string. Keep the string about 1/8"
(3mm) out of the front winch line
guide. Note: The less turns of string
in the drum the less chance for
string to be out of the groove.
5. Do the same procedure on the
Main Sail Control String but keep
the string about 1-5/8"(40mm) out of
the rear winch line guide.
6. Do the sail adjustment in page
21, after you satisfied with the
adjustment then secure the drum
with the screw comes with the
servo. Next secure the Winch Servo
Cover
with two Standoff
34
3x25mm Wood Screw
. You will
2
need to trim a notch for the string to
go.
94
on the
39
in place.
43
27
27
and
20
1-METER
1-METER
1-METER
America's Cup Racing Yacht
America's Cup Racing Yacht
America's Cup Racing Yacht
2
34
20
18
39
23
Advertisement
