Page 2
INTRODUCTION All of us at Thunder Tiger want to thank you for choosing the Scale Fishing Boat. These boats are full equipped with radio, servos, and forward/backward 50A ESC, 4.5A 6V battery and wall charger that will provide lots of scale boating fun.
Page 4
Follow the manual step by step. The boat name is indicated in each photo as the manual is written for all scale fishing boats. There are some steps may vary,you may skip the steps if manual does not mention. Step1:Open box and take out the boat carefully. Step2:Remove the tight band and all wraps, place the boat on wood stand.
Page 5
Step6:Install Receiver in place as shown. Step3:Do not trash the box as there is a small box which contains master, rigging and sails. This will be assembled later. Step4:Locate Transmitter, Receiver, Battery, Wall Charger and Battery Cord. Step5:Remove the deck from the hull by loosening two retainers...
Page 6
Step8:Secure battery with furnished Velcro in the Step7:Plug the rudder servo connector at CH1 hull as shown. Connect Battery to ESC with and ESC connector at CH2. the Battery Cord. Note: Red to Red and Black to Black. Well organize the wires and make sure the all wires do not contact the drive shaft.
Page 7
Step9:Refer to furnished radio manual and set up your radio. Always switch transmitter on first, ESC last. Turn off ESC first and transmitter last. Make sure Throttle and Steering are at neutral pos ition and in correct direction. Please see ESC manual at page14. counter clockwise Right Right Turn...
Page 12
Step15:Hook up the riggings as shown. Step13:Install the Fishing Crane in place. Step14:Locate the holes on the crane and press the tips of the fishing gear into the holes. Step16:Route the antenna on the fishing gear.
Page 13
Congratulations! This Scale Fishing Boat is ready to go now. Follow the Radio Manual to do frequency and range test before boating. Enjoy the boating fun...
Page 14
VELOCI PRO-R ELECTRONIC SPEED CONT ROLLER Warning Product no. #8023 Do not leave your R/C model unattended when the battery is connected. Always make sure the switch is off unless under adjust- Features ment. Never touch to water without any protection. The anti- i - Using the latest SMD-MOS FETs water protection is strongly recommended.
If you make a mistake during the set-up procedure, donÕ t worry. Disconnect the battery for about 10 seconds and start again from the first step. * Any service information please contacts your local retailer for further detail. Do not send the defective product directly to the Thunder Tiger Corp.