Advertisement
3
Keel and Rudder Tube
Assembly
16
17
21
22
22
1. Insert the Keel Tube
from hull
top and reach the hull bottom then
epoxy the two End Caps
16
place. There are three big end
caps and one small end cap.
The small one for the bottom hull.
Note: end caps are working as
waterproof and epoxy will help to
fill the gap between cap and
tube. Keel Tube might need to
trim the length , to keep it level
with the deck. However, do not
leave any excess epoxy on the
inside the tube as it will be difficult
to insert the keel shaft if there is
any hardened epoxy inside.
Note: You may need to sand
contact area A of the hull if tube
is higher than the deck.
2. Using the same way to install
Rudder Tube
and the other
17
two end caps in place then allow
the epoxy to cure.
1-METER
1-METER
1-METER
America's Cup Racing Yacht
America's Cup Racing Yacht
America's Cup Racing Yacht
in
21
16
22
A
21
22
21
16
07
21
17
21
Advertisement
