Tools And Materials Needed - USSC Clayton 1537Q Owner's Manual

You've purchased one of America's Finest Wood and Coal Burning Furnaces.
By heating with wood and coal you're helping to CONSERVE AMERICA'S ENERGY!
Wood is our Renewable Energy Resource. Please do your part to preserve our wood
supply. Plant at least one tree each year. Future generations will thank you.
NOTE:
YOUR UNIT MUST BE INSTALLED BY A QUALIFIED FURNACE INSTALLER.
IMPROPER INSTALLATION COULD VOID YOUR WARRANTY!
NOTE:
(See Page 5, First Paragraph)

tools and materials needed

TOOLS
Pencil
6 Foot Folding Rule or Tape
Tin Snips
Drill, Hand or Electric
Drill Bit (For Sheet Metal Screws) 1/8" Dia.
Screw Driver (Blade-Type)
Gloves
Sabre Saw
5/16" Nut Driver or
5/16" Socket with Rachet
CONGRATULATIONS!
MATERIALS
6" Pipe, 6" Elbow, Collar and Thimble; as required
(24 gauge min.)
1/2" Sheet Metal Screws
6" Inside Diameter Listed Residential Type or
Building Heating Appliance Chimney or Existing
Masonry Chimney (SEE Page 8).
Electrical Wiring
6" Draft Regulator
1/2" Conduit
(Conduit Connectors)
Furnace Cement (Manufacturer Recommends:
Rutland Black - Code 78 or Equivalent
Plenum and Duct Work as Required
2