Toro Reelmaster 3550-D Service Manual page 321

Assembly (Fig. 14)
1. Apply antiseize lubricant to upper threads of adjust-
ment rod and lower threads of height adjusters. Assem-
ble height adjuster assembly as shown.
2. If both height adjusters were removed, fit one height
adjuster assembly to the cutting unit side plate and se-
cure with carriage bolt and flange nut. Do Not tighten the
flange nut at this time. Ensure the height adjustment bolt
and one (1) washer is above slot in side plate and one
(1) washer and lock nut is below slot in side plate.
3. Position front roller between height adjuster assem-
blies and secure height adjuster assembly to cutting unit
side plate with carriage bolt and flange nut. Do Not tight-
en the flange nut at this time. Ensure the height adjust-
ment bolt and one (1) washer is above slot in side plate
and one (1) washer and lock nut is below slot in side
plate.
4. Use new cotter pins and install the cotter pins and
clevis pins securing the height adjustment rods to the
groomer gear box and idler arm.
5. Adjust the cutting unit height of cut (see Cutting Unit
Operators Manual).
6. Check groomer reel height and adjust as needed.
Reelmaster 3550−D/3555−D/3575−D Page 9 − 19 Universal Groomer