Spline Insert Tool
Toro Part Number: TOR4112 (8 tooth)
Use the spline insert tool for rotating the cutting reel
when hydraulic motor is removed. Also, use this tool for
installation of threaded inserts into the cutting reel shaft.
Roller Rebuild Kit
Toro Part Number: 115- -0803
This tool kit is used to assemble the cutting unit rollers.
Tools in this kit are also available individually as follows:
115--0852 Inner Seal Tool
115--0853 Bearing/Outer Seal Tool
107--8133 Bearing Installation Washer
Plastic Plug
Toro Part Number: 2410- -30 (for 5 inch reels)
94- -2703 (for 7 inch reels)
This cap is used for placement into the cutting unit side
plate when the cutting reel motor is removed. It prevents
dirt and debris from entering the cutting reel bearing
area.
Reelmaster 3550--D/3555--D/3575--D
Bearing Installation
Inner Seal
Tool
Page 7 - - 7
Figure 13
Washer
Bearing/Outer Seal
Tool
Figure 14
Figure 15
DPA Cutting Units