Toro Reelmaster 3550-D Service Manual page 25

DANGER
Because diesel fuel is flammable, use caution
when storing or handling it. Do not smoke while
filling the fuel tank. Do not fill fuel tank while en-
gine is running, hot or when machine is in an en-
closed area. Always fill fuel tank outside and
wipe up any spilled diesel fuel before starting the
engine. Store fuel in a clean, safety−approved
container and keep cap in place. Use diesel fuel
for the engine only; not for any other purpose.
Fuel Tank Removal (Fig. 5)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch. Unlatch and raise hood.
IMPORTANT: Follow all local codes and regulations
when recycling or disposing waste fuel.
2. Drain fuel from the tank into a suitable container. If
necessary.
3. Disconnect seat switch from the electrical harness.
Remove seat and seat support straps from the frame.
4. Remove fuel hose strap and both fuel hoses from the
fuel tank (Fig 6). Remove fuel tank from the machine.
Clean Fuel Tank
Clean the fuel tank every 2 years. Also, clean the fuel
tank if the fuel system becomes contaminated or if the
machine is to be stored for an extended period.
1. Remove fuel tank from the machine (see Fuel Tank
Removal).
2. Flush fuel tank out with clean diesel fuel. Make sure
tank is free of contaminates and debris.
3. Install fuel tank to the machine (see Fuel Tank Instal-
lation).
Fuel Tank Installation (Fig. 5)
1. Position fuel tank to the machine.
2. Connect both fuel hoses to the tank and secure with
hose clamps.
3. Install fuel hose strap to top of tank making sure that
fuel lines are properly positioned in grooves in tank.
Reelmaster 3550−D/3555−D/3575−D
1
1. Seat support strap
2. Hex flange head screw
3. Electrical harness
4. Connect wire harness connector to the seat switch.
Route seat switch wire under seat support strap. Secure
seat support straps and seat to the frame (see Operator
Seat in Chapter 6 − Chassis in this manual).
5. Check that fuel tank support contacts the bottom of
the fuel tank but does not raise tank from machine
frame. Adjust location of support if necessary.
6. Check for correct seat operation. Also check that
seat switch wires and connector are not pinched and do
not contact any moving parts.
7. Fill fuel tank.
Page 3 − 7
3
4
5
2
Figure 6
4. Fuel hose strap
5. Fuel hose
Kubota Diesel Engine