Toro Reelmaster 3550-D Service Manual page 30

Make sure lift or hoist can support the total
weight of the engine before removing the cap
screws from the engine and engine brackets.
13.Remove hex nuts, cap screws, and washers from the
center of the three engine mounts.
RIGHT
FRONT
4
5
6
7
1. Engine mount bracket
2. Flange nut (2)
3. Flange screw (2)
4. Pump mount plate
Kubota Diesel Engine
CAUTION
3
8
5. Hardened washer (4)
6. 10 mm cap screw (4)
7. 8 mm cap screw
One person should operate lift or hoist while the
other person guides the engine out of the ma-
chine.
IMPORTANT: Make sure not to damage the engine,
fuel and hydraulic lines, electrical harness, or other
parts while removing the engine.
14.Remove engine slowly from the machine.
1
2
10
9
Figure 12
Page 3 − 12
CAUTION
8. Hardened washer
9. Long spacer (4)
10. Short spacer
Reelmaster 3550−D/3555−D/3575−D