Toro Reelmaster 3550-D Service Manual page 296

A. Apply a thin layer of grease to inner lip of seal and
carefully position non−drive side groomer plate onto
groomer shaft and slide to cutting unit.
B. Apply antisieze lubricant to the outside diameter
of the pivot hub and position pivot hub to cutting unit
(Fig. 6).
C. Apply Loctite to two (2) socket head screws and
secure pivot hub to cutting unit side plate.
IMPORTANT: The shoulder bolts that secure the
quick−up ball joint rod to the groomer plate have
a patch−lock feature. If previously removed
shoulder bolts are being re−installed, apply
medium strength thread locker to threads before
installation.
D. Apply antiseize compound to shoulder area only
of shoulder bolt that secures quick−up ball joint rod to
groomer plate. Install spacer and shoulder bolt and
tighten from 17 to 21 ft−lb (23 to 28 N−m).
E. Install hydraulic reel motor to cutting unit (see Hy-
draulic Reel Motor Installation in Chapter 7 − Cutting
Units in this manual).
3. Install groomer plate assembly to groomer drive side
of cutting unit:
A. Position groomer shim to cutting unit side plate.
B. Apply a thin layer of grease to inner lip of seals
and carefully position drive side groomer plate onto
groomer shaft and slide to cutting unit.
C. Apply antisieze lubricant to the outside diameter
of the pivot hub and position pivot hub to cutting unit
(Fig. 6). Apply Loctite to two (2) socket head screws
and secure pivot hub to cutting unit side plate.
D. Apply antisieze lubricant to the outside diameter
of the pivot hub and position idler plate assembly to
pivot hub.
E. Connect extension spring to stud on groomer
plate. Make sure that spring is in the stud groove and
that spring hook is positioned toward the drive pulley.
IMPORTANT: The shoulder bolts that secure the
quick−up ball joint rod to the groomer plate have
a patch−lock feature. If previously removed
shoulder bolts are being re−installed, apply
medium strength thread locker to threads before
installation.
F. Apply antiseize compound to shoulder area only
of shoulder bolt that secures quick−up ball joint rod to
groomer plate. Install spacer and shoulder bolt and
tighten from 17 to 21 ft−lb (23 to 28 N−m).
Belt Driven Groomer
2
1. Drive pulley
2. Driven pulley
1
1. Pivot hub
(non−drive side)
G. Slide pulley spacer and washer(s) onto groomer
shaft.
H. Apply antiseize lubricant to square key that loc-
ates drive pulley. Position key into shaft slot.
NOTE: To prevent cutting reel from turning when in-
stalling drive pulley, block cutting reel with piece of
wood.
I. Apply Loctite #242 to threads of flange head
screw that secures drive pulley to pivot hub shaft.
Slide drive pulley onto shaft and secure with flange
head screw. Torque screw from 27 to 33 ft−lb (37 to
44 N−m).
Page 8 − 8
1
3
Figure 5
3. Straight edge
Antiseize
Lubricant
Figure 6
2. Pivot hub
(drive side)
Reelmaster 3550−D/3555−D/3575−D
2
Antiseize
Lubricant