Switching The Headphones On - Sennheiser MOMENTUM Wireless M3AEBTXL Instruction Manual

Using the headphones
16 | MOMENTUM Wireless M3AEBTXL

Switching the headphones on

WARNING
Danger of hearing damage due to high volume levels!
Listening at high volume levels can lead to permanent
hearing defects.
▷
Before putting the headphones on, adjust the volume
to a low level (> 20).
▷
Do not continuously expose yourself to high volume
levels.
WARNING
Risk of getting caught when unfolding the ear cups!
When the ear cups are unfolded, you may get caught in
the joints and injure yourself.
▷
When unfolding the ear cups, keep sufficient distance
to the joints so that no skin is caught in the joints.
▷
Unfold the two ear cups (right and left).
The joints click into place. The headphones switch on. You hear
the voice prompt "Power on" and the LED lights up green for
2 seconds.
If a paired Bluetooth device is within the transmission range, you
hear the voice prompt "Device (1) connected". The LED lights up
blue for 2 seconds.
OFF
2s
Make sure that Bluetooth is already activated on your Blue-
tooth device when switching on the headphones.
If Bluetooth is activated and the headphones cannot find a
paired Bluetooth device within a few minutes, you hear the
voice prompt "No device found". The LED lights up red for 2
seconds. The headphones switch to standby mode.
Power on
Connected
2s
"Power on" No connection
2s
ON
Click
"Device (1)
connected"
"No device
found"