Using The Menu - Uniden UDW-10003 User Manual

Using the Menu

To open the menu, To open the menu,
press press
Use Use
and and
DOWN DOWN
to move to move
the cursor the cursor
Item
Audio Vol
Scan Time
CAM1 – CAM4
Pair CAM
System Setup sub-menu
Brightness
TV out
Power Save
Factory Reset
10
OK OK
Audio Vol Audio Vol
Scan Time Scan Time
CAM1 CAM1
UP UP
CAM2 CAM2
CAM3 CAM3
CAM4 CAM4
Pair CAM Pair CAM
System System
Factory Factory
Use it to
Adjust the volume of the audio from the camera. Choose a value from 0 (off)
through 20 (maximum).
Set the length of time the receiver spends on each active camera during a scan
(see page 15) or activate quad display (see page 16).
Turn each of the four camera channels On (enabled) or Off (disabled).
Pair a camera to the selected channel (see page 13).
Adjust the brightness of the display. Choose a value from 1 (min) through 15
(max).
Change the video output format from NTSC (North America) to PAL (Europe).
Turn on power save mode. If you set this to field to Auto, the display turns off
if it's idle for more than one minute. (The audio will remain active.) To turn the
display back on, press
Reset the receiver to factory defaults. Any changes or settings will be lost.
The selected The selected
item is item is
highlighted highlighted
10 10
OFF OFF
ON ON
ON ON
ON ON
ON ON
1 2 3 4 1 2 3 4
Setup Setup
To open the To open the
System Setup System Setup
Reset Reset
sub-menu, press sub-menu, press
To close the menu, press To close the menu, press
.
Ok
Use Use
LEFT LEFT
and and
RIGHT RIGHT
to scroll to scroll
9 9
through the through the
options for options for
the item the item
Brightness Brightness
TV out TV out
Power Save Power Save
OK OK
11 11
10 10
NTSC NTSC
OFF OFF
OK OK