Replacing The Fuse - Yamaha Nouv AT135 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
stant-voltage) battery charger is re-
quired. Using a conventional battery
charger will damage the battery. If
you do not have access to a con-
stant-voltage battery charger, have
a Yamaha dealer charge your bat-
tery.
_
To store the battery
1. If the vehicle will not be used for
more than one month, remove the
battery, fully charge it, and then
place it in a cool, dry place. NO-
TICE: When removing the bat-
tery, be sure the key is turned
to "OFF", then disconnect the
7
negative lead before discon-
necting the positive lead.
2. If the battery will be stored for
more than two months, check it at
least once a month and fully
charge it if necessary.
3. Fully charge the battery before in-
stallation.
4. After installation, make sure that
the battery leads are properly con-
nected to the battery terminals.
NOTICE
_
Always keep the battery charged.
Storing a discharged battery can
cause permanent battery damage.
_
[ECA16302]

Replacing the fuse

ECA16530
ZAUU0412
1. Fuse cover
2. Screw (x1)
The fuse holder is located in the stor-
age compartment under the seat, be-
hind the starter relay cover. (See page
4-9 for seat opening procedures.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to "OFF" and turn off
2. Remove the starter relay cover by
3. Pull the starter relay out.
7-29
1
all electrical circuits.
removing the screw.
EAUU0421
2