Replacing A Turn Signal Light Bulb - Yamaha Nouv AT135 Owner's Manual

1
ZAUU0421
1. Tail/brake light bulb socket
3. Remove the socket (together with
the bulb) by turning it counter-
clockwise.
4. Remove the burnt out bulb by
pushing it in and turning it counter-
clockwise.
ZAUU0422
1. Tail/brake light bulb
PERIODIC MAINTENANCE AND ADJUSTMENT
5. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
6. Install the socket (together with the
bulb) by turning it clockwise.
7. Install the panel and the seat.
1
7-32
Replacing a turn signal light
bulb
1
2
ZAUU0423
1. Rear turn signal light lens
2. Screw
1. Remove the turn signal light lens
by removing the screw.
2. Remove the burnt-out bulb by
pushing it in and turning it counter-
clockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screw. NOTICE: Do not over-
tighten the screw, otherwise
the lens may break.
EAU24204
7
[ECA11191]