Replacing The Fuse; Supporting The Motorcycle - Yamaha TT-R110EL 2019 Owner's Manual

Periodic maintenance and adjustment

Replacing the fuse

The fuse is located inside the battery
coupler. (See page 7-27.)
3
1
2
1. Battery coupler
2. Fuse
3. Spare fuse
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to "OFF" and turn off
all electrical circuits.
2. Disconnect the battery coupler.
3. Remove the blown fuse, and then
install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a higher amperage
rating than recommended to
avoid causing extensive dam-
age to the electrical system and
possibly a fire.
Specified fuse:
10.0 A
4. Connect the battery coupler.
5. Turn the key to "ON".
6. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
EAU50432
[EWA15132]
7-29

Supporting the motorcycle

Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other mainte-
nance requiring the motorcycle to
stand upright. Check that the motorcy-
cle is in a stable and level position be-
fore starting any maintenance. A
strong wooden box can be placed un-
der the engine for added stability.
To service the front wheel
1. Stabilize the rear of the motorcy-
cle by using a motorcycle stand
or, if an additional motorcycle
stand is not available, by placing a
jack under the frame in front of the
rear wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
a jack either under each side of the
frame in front of the rear wheel or under
each side of the swingarm.
EAU24351
7