Storage - Yamaha Nouv AT135 Owner's Manual

MOTORCYCLE CARE AND STORAGE
●
Before operating the scooter
test its braking performance
and cornering behavior.
_
NOTICE
_
● Apply spray oil and wax spar-
ingly and make sure to wipe off
any excess.
●
Never apply oil or wax to any
rubber parts, plastic parts or
headlight, taillight and meter
lenses, but treat them with a
suitable care product.
● Avoid using abrasive polishing
compounds as they will wear
away the paint.
_
TIP
_
8
●
Consult a Yamaha dealer for ad-
vice on what products to use.
●
Washing, rainy weather or humid
climates can cause the headlight
lens to fog. Turning the headlight
on for a short period of time will
help remove the moisture from the
lens.
_

Storage

Short-term
ECAU0020
Always store your scooter in a cool, dry
place and, if necessary, protect it
against dust with a porous cover.
NOTICE
_
●
Storing the scooter in a poorly
ventilated room or covering it
with a tarp, while it is still wet,
will allow water and humidity to
seep in and cause rust.
● To prevent corrosion, avoid
damp cellars, stables (because
of the presence of ammonia)
and areas where strong chemi-
cals are stored.
_
Long-term
Before storing your scooter for several
months:
1. Follow all the instructions in the
"Care" section of this chapter.
EAU26301 2. Drain the carburetor float chamber
3. Fill up the fuel tank and add fuel
ECA10820
4. Perform the following steps to pro-
8-3
by loosening the drain bolt; this will
prevent fuel deposits from building
up. Pour the drained fuel into the
fuel tank.
stabilizer (if available) to prevent
the fuel tank from rusting and the
fuel from deteriorating.
tect the cylinder, piston rings, etc.
from corrosion.
a. Remove the spark plug cap
and spark plug.
b. Pour a teaspoonful of engine
oil into the spark plug bore.
c. Install the spark plug cap onto
the spark plug, and then place
the spark plug on the cylinder
head so that the electrodes are
grounded. (This will limit spark-
ing during the next step.)
d. Turn the engine over several
times with the starter. (This will
coat the cylinder wall with oil.)
WARNING! To prevent dam-
age or injury from sparking,