Table of Contents
Advertisement
2) Press
select/ch, "
Store/Edit Name
3) Store the name (up to 16 characters) by using the number keypad.
• See the "Steps for entering names and special characters" (see page 28).
• Use call id/
and
/RocketDial/
• Use xfer/del to delete characters as needed.
• Press and hold xfer/del to delete all the characters.
If a name is not required, go to step 4.
4) Press select/ch to store the name,
"
Store/Edit No.
" appears.
5) Press the number keypad to enter the phone number (up to 20 digits),
press select/ch to store the number.
6) "
" appears. Press + or - to move
Distinctive Ring
the pointer to one of the Distinctive Ring options, then
press select/ch.
If you choose not to store a "
Distinctive Ring
the "
No Selectn
" option.
7) "
Speed Dial
" appears. Press + or - to move the pointer to
select the Speed dial location (10 locations: SPD1-SPD0).
If you choose not to store the name/number as a Speed Dial, simply
select the "
No Selectn
" option.
8) Press
select/ch. You will hear a confirmation tone and
"
Done!
" appears on the display.
" appears.
to move the cursor to the desired location.
", simply select
• When the memory is
full, you will hear a
beep and "
Memory
Full
" appears. You
cannot store names
and numbers.
• The pause key counts
as one digit. Pressing
redial/p more than
once increases the
length of pause
between numbers.
• If you select a Speed
dial location a number is
already stored, the new
number will replace the
old number, and the old
number will be stored as
a phonebook location.
P H O N E B O O K
[ 27 ]
Advertisement
Table of Contents
