Table of Contents
Advertisement
D. Choose the dialing mode
Most phone systems use tone dialing, which sends DTMF tones through the phone lines.
However some phone systems still use pulse dialing such as in rural areas. The default
setting is tone dialing. Depending on your dialing system, set the mode as follows:
• If you are not sure of
1) When the phone is in the standby mode, press menu/mute.
your dialing system, set
the unit to tone dialing.
Make a trial call. If the
call connects, leave the
setting as is, otherwise
2) Press + or - to move the pointer to "
set the unit to pulse
dialing.
• If your phone system
3) Press select/ch and the display will show the current setting.
requires pulse dialing
(The initial setting is Tone.)
and you need to send
DTMF tones in certain
4) Press + or - to change the selection.
situations during a call,
you may "switch-over"
5) Press select/ch, and you will hear a confirmation tone.
to tone dialing. (Refer
to "Tone Dialing Switch-
6) Press end to exit.
over" on page 22.)
Terminology
Throughout this manual, terms such as Standby and Talk Mode are used. Below is the
terminology explanation.
Standby Mode - The handset is not in use, is off the base, and talk/flash or spkr have not
been pressed. A dial tone is not present.
Talk Mode - The handset is not in the base and talk/flash or spkr has been pressed
enabling a dial tone. "
[ 14 ]
G E T T I N G S T A R T E D
Dial Mode
".
Talk
" appears on the display.
Advertisement
Table of Contents
