Additional Information; Changing The Digital Security Code; Installing The Beltclip - Uniden DXAI 5188-2 Series Owner's Manual

Changing the Digital Security Code

To protect you against misbilled calls which might result from your phone being
activated by other equipment, the cordless phone provides AutoSecure
(which electronically locks your phone when each handset is in the main base or
charging cradle) and Random Code
of over 262,000 digital security codes for each handset and main base).
If the handset battery pack is completely discharged or the battery pack is removed,
the digital security code will be lost. If this happens, a new security code is set
automatically the next time the battery pack is charged.
In the rare situation that you suspect another cordless telephone is using the same
security code, you can change the code.
1) Remove the handset from the main base unit or charging cradle. Press and hold
2) While holding find hs, place the handset in the main base unit, and leave the
3) Remove the handset from the main base. Then place the second handset in the
4) Press talk/flash on one handset. Once you make sure

Installing the Beltclip

To attach the beltclip
Insert the beltclip into the holes on each side of the handset. Press down until it clicks.
To remove the beltclip
Pull both sides of the beltclip to release the tabs from the holes.
[ 56 ] A D D I T I O N A L I N F O R M A T I O N
find hs on the main base.
handset in the main base for more than 3 seconds.
main base unit and wait for more than 3 seconds. You do not need to press find
hs this time.
display, press end. Then, try with the second handset. If each handset displays
, a new security code is set. Otherwise, return to step 1 and try again.
TM digital security (which automatically selects one
TM
appears on the
www.uniden.com