Ultra Start 25XX Series Install Manual page 6

INSTALLATION MANUAL
Page 6
Side View
(-)250ma Output
(+)250ma Output
(-)250ma Output
(-)250ma Output
(-)Input
(-) Input
(-)250ma Output
(+)250ma Output
Note-250ma outputs are low current and are designed to activate
relays
AUX #1 (Hold 1&3)*/ (-) HORN OUTPUT*
Programmable*
Programmable
AUXILIARY OUTPUT #2 (Hold 2&3)
(+) Input
(+)DISCONNECT/ (+) START INPUT**
*The default output of the Green wire is Negative Horn Output. The auxiliary
outputs must be programmed on before they will operate.
Jumper Selections - Back View
The jumpers control the output from the White wire on the 6- pin harness. This is
a 30amp relayed output. To change the output of the wire access the jumpers by
sliding the plastic cover off the top of the case. Move the jumper to one of the
following positions.
If the jumper is in position #1 the output on the white wire will be 2nd Starter
If the jumper is in position #2 the output on the white wire will be 2nd Accessory
If the jumper is in position #3 the output on the white wire will be 2nd Ignition
Note: The factory default setting of the selectable output jumper is position
#3 second ignition output.
Door Lock
12volt Inverter Output
Door Unlock
Passenger Door Unlock
Sensor Pre-Warn Input
Sensor Full-Warn Input
Sensor Ground Output
Sensor 12V+ Power Output
3 2 1
REMOTE VEHICLE STARTER/ALARM
Green
Red
Blue
Pink
Blue
Green
Black
Red
Green
Pink
Blue
Jumper Access