Ultra Start 25XX Series Install Manual page 18

Remote starter/ alarms
Table of Contents

Advertisement

INSTALLATION MANUAL
Page 18
Menu 2 - Additional Settings
Ignition ON-OFF-ON-OFF-ON
Press & Release Program Button
Press Unlock Button
Setting 1 Secure Valet Mode - Length of time required to set the system into Service Mode
1) Secure Valet
*2) Normal Valet
Press & Release the Program Button 1 Time (Setting 1) confirmed 1 LED flashes.
Press & Hold the Program Button until the appropriate # of park light/sirenchirps, then release.
Press & Release the Program Button to proceed to the next step
Setting 2 Parking Light/Trunk Output (White and Red/White on 14-pin)
1) 30 sec. Output
2) Negative Park Lights
*3) Park Lights
Press & Release the Program Button 2 Times (Setting 2) confirmed 2 LED flashes.
Press & Hold the Program Button until the appropriate # of park light/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 3 Horn chirp Timing (White/Blue on 4-pin) *Must be programmed for horn output.
1) 5 ms Pulse Output
2) 15 ms Pulse Output
*3) 10 ms Pulse Output 3 Flashes/chirps
Press & Release the Program Button 3 Times (Setting 3) confirmed 3 LED flashes.
Press & Hold the Program Button until the appropriate # of park light/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 4 # Button
1) Trunk Release
2) Garage door
3) Car Finder
Press & Release the Program Button 4 Time (Setting 4) confirmed 4 LED flashes.
Press & Hold the Program Button until the appropriate # of park light/sirne chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 5 Reservation Mode ("M" units only)
1) Manual Reservation
*2) Auto Reservation
1 Flash/chirp
2 Flashes/chirps
1 Flash/chirp
2 Flashes/chirps
3 Flashes/chirps
1 Flash/chirp
2 Flashes/chirps
1 Flash/chirp
2 Flashes/chirps
3 Flashes/chirps # Button Activates Car Finder Mode
1 Flash/chirp
2 Flashes/chirps
REMOTE VEHICLE STARTER/ALARM
Hold the Program Button for 15 seconds
Hold the Program Button for 5 seconds
Park Lights on for 30 seconds when Unlock is pressed
Switches the Park Lights/Trunk Outputs
2 Park Light Flashes when Unlock is pressed
Short(Quiet) Horn Output Pulses
Long(Loud) Horn Output Pulses
Normal(Medium) Horn Output Pulses
# button activates trunk release.
# button activates optional garage door interface.
Activate Reservation Mode by pressing Button #4
Activate Reservation Mode by pressing brake
*(Default Settings)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

26xx series25 series26 series

Table of Contents