Table of Contents
Advertisement
DIAGNOSTICS
Alarm Diagnostics
If the alarm system is triggered while armed, the system will retain in memory the cause of the trigger. The
diagnostics can then be used to determine what the cause of the trigger was. When disarming the alarm,
the siren/horn will chirp 3 times instead of the usual 2 times to indicate the alarm had been triggered.
The system's LED will also flash in pulses to indicate which input triggered the alarm.
NOTE: LED status will be cleared when ignition is turned ON. For proper memory clearing, insure to
connect the ignition input to the ignition on the vehicle
Park Light Flashes
Two Flashes
Three Flashes
Four Flashes
Five Flashes
None
None
None
None
Additional LED Flashes
Note: While the system is disarmed and the ignition is in the off position, the LED will activate from the
following triggers.
1) The door is opened. The LED will Stay on until the door is closed.
2) The hood is opened. The LED will stay on until the hood is closed.
3) The Shock Senor. The LED will flash when impact is detected.
4) The Aux Sensor. The LED will flash when the input is triggered.
12
Installation Guide
LED Flashes
Two Flashes
Three Flashes
Four Flashes
Five Flashes
Off
On Solid
Single Flashes
Rapid Flashes
Diagnostic
Shock Sensor Triggered
Door Input Triggered
Ignition Input Triggered
Hood Input Triggered
System Disarmed
Valet Mode
System Armed
Passive Arming
Advertisement
Table of Contents
