Table of Contents
Advertisement
Light Bulb Replacement
To replace the light bulb in your U-Line unit:
Light
Housing
Lens
Figure 18. Light Housing Lens
1. Grasp the edges of the light housing lens opposite the
exposed tab and gently push the lens toward the tab
(Figure 18).
2. Pull the edge of the lens down and swing it out of the
light housing.
IMPORTANT
IMPORTANT
ALWAYS use a genuine U-Line replacement bulb
(Part No. 31317) in the light housing. Use of any
other bulb within the housing will generate
excessive heat, causing damage to the light housing
and cabinet interior, and will compromise the
precise temperature control of your unit.
3. Replace the bulb only with a genuine U-Line Part No.
31317 replacement.
4. Replace the lens by first inserting the tab side back into
the housing at a slight angle. While gently pushing the
lens towards the tab end, push the free end up into the
housing, and release when you will hear a snap/click.
Wine Rack Removal/Installation
To remove a rack from the cabinet:
1. Grasp the end of the rack, and gently slide it out until
it stops.
2. Remove any bottles stored on the rack.
3. Press the left rack release lever (Figure 19) down, and
at the same time, lift the corresponding right rack
release lever up, and pull the rack out until it is free of
the tracks and the cabinet.
Rack
Release
Lever
Figure 19. Rack Removal/Installation
12
Tab
ULIN_0001_A
ULIN_0207_A
2275ZWC & 2275ZWCOL
IMPORTANT
IMPORTANT
Do not remove the track side rails from the cabinet.
To insert a rack in the cabinet:
1. Align the left and right rack channels with the tracks
in the cabinet, and ensuring an even track
engagement on both sides, gently push the rack into
the cabinet until it stops.
2. Before reloading the rack, ensure proper operation of
the travel stops in the left and right track rails by
pulling the rack out gently until it completely stops.
12
WOOD TRIM FINISHING
Interior components of your U-Line unit are equipped
with a natural wood trim for appearance and durability.
Although this wood trim has been coated with a clear
sealer at the factory, it is recommended that the trim be
stained (if desired), and receive a final finish coating prior
to the unit going into full-time service.To prevent
permanent damage to the inner liner of your unit, the
wood trim MUST be removed from the unit for staining
and/or finishing. Allow stain/finish to dry thoroughly (at
least 24 hours per coat) in accordance with the product
manufacturer's instructions prior to reinstallation. Failure
to do so may cause the inner liner of the unit to have a
permanent odor, which is not covered by the warranty.
If staining the trim is desired, it must be done before the
application of any type of final finish. Review the
following staining/final finish and final finish-only
guidelines when staining/ and or sealing the wood to
ensure proper adhesion and durability of the finish.
Note: Glass in door is tinted. Stain may look darker when
door is closed.
Staining and Final Finish Application
1. Remove all screws securing wood trim to interior
components, and remove the trim from the cabinet
interior.
IMPORTANT
IMPORTANT
DO NOT use oil-based stains on wood trim. Vapors
from oil-based stains will permanently penetrate
the liner and will not dissipate over time.
2. Apply Minwax
®
Water-Based Wood Stain to wood with
a synthetic bristle brush or a foam applicator. Allow
stain to penetrate approximately three minutes. Before
the stain is dry, take a stain dampened rag and remove
any excess stain remaining. Wipe in the direction of the
grain with medium pressure to achieve the desired stain
color.
3. After two hours, repeat step 2. This will even out the
color of the wood.
Advertisement
Table of Contents
