Dual Temperature Zones; Temperature Display - U-Line WINE CAPTAIN 2275XWCOL Use And Care Manual

Dual Temperature Zones

Your unit has been designed to provide two temperature
zones (top and bottom) in the cabinet. Each zone can be
adjusted within the 4 following temperature ranges:
Note: These are product temperatures, not air
temperatures.
WINE CAPTAIN TEMPERATURE RANGES
RW (Red Wine)
WW (White Wine)
SW (Sparkling Wine)
BV (Beverage)
UPPER ZONE CONTROLS
Power Warmer
Cooler Display
Figure 4. Temperature Display

Temperature Display

The electronic control is configured to show a single
temperature continuously in each display (Figure 4).
ADJUSTING SET-POINT TEMPERATURE
IMPORTANT IMPORTANT
Adjust the set-point temperature and wait 24 hours
for the temperature to stabilize before rechecking.
.
Power Warmer Cooler Display
UPPER ZONE CONTROLS
Warmer
Power Cooler Display
Figure 5. Adjusting Set-Point Temperature
Default Range
55°F 60° - 50°F
50°F 55° - 45°F
45°F 50° - 40°F
38°F 60° - 34°F
Light
Display Warmer Cooler
LOWER ZONE CONTROLS
ULIN_1001_A
Light
Display Warmer Cooler
LOWER ZONE CONTROLS
ULIN_1009_A
Light
Display
Warmer Cooler
LOWER ZONE CONTROLS
ULIN_1012_A
2275ZWC & 2275ZWCOL
This default temperature is used by the controller to
maintain the temperature zones in your unit.
The default temperatures are a recommendation. If
further temperature adjustments are required, use the
following procedure to adjust the set-points.
1. Press and release the desired zone WARMER icon to
put the controller in the SET TEMPERATURE mode. The
current range symbol will show on the display (top,
Figure 5).
Note: If no further action is taken, this mode will self
cancel in five seconds, and the original set-point
temperature will be displayed.
2. Press the WARMER or COOLER icon to scroll to the
desired range (RW, WW, SW, BV).
3. When the desired range is displayed, press the LIGHT
icon to display the current set-point temperature
(bottom, Figure 5).
4. Press the WARMER or COOLER icon as required to
adjust the set-point temperature.
5. When the desired set-point is displayed, press the LIGHT
icon. The new set-point will show in the display.
6. Repeat for other zone display if required.
IMPORTANT IMPORTANT
Whenever a zone range is changed (example: RW to
WW), it will revert to the factory default.
DISPLAYING ACTUAL ZONE TEMPERATURE
To display actual zone temperatures (not set-point):
1. Press and hold the WARMER icon for the desired zone
for approximately five seconds until unit beeps, and
release when the decimal in the display begins to flash
(Figure 6).
2. The display will show the actual zone temperature.
3. After five seconds, the display will return to the set-
point temperature.
UPPER ZONE CONTROLS
Power Warmer
Cooler Display
Figure 6. Displaying Zone Temperature
Light
Display Warmer Cooler
LOWER ZONE CONTROLS
ULIN_1011_A
5