Glass Shelf Removal/Installation; Light Bulb Replacement; Wine Rack Removal/Installation - U-Line Origins 1075BEVS00 Use And Care Manual

Glass Shelf Removal/Installation

Slide the shelves onto lower sets of ribs, making sure the
decorative graphics are on the underside of the shelves
(Figure 14).
Figure 14
IMPORTANT IMPORTANT
• Make sure the shelves are inserted fully into the
unit.
• The white edge strip toward the rear prevents
cans and bottles from freezing against the cold
evaporator.

Light Bulb Replacement

To replace the light bulb in your U-Line unit:
Light
Housing
Lens
Figure 15
1. Grasp the edges of the light housing lens opposite the
exposed tab and gently push the lens toward the tab
(Figure 15).
2. Pull the edge of the lens down and swing it out of the
light housing.
10
Tab
ULIN_0001_A
1075BEV
IMPORTANT IMPORTANT
ALWAYS use a genuine U-Line replacement bulb (P/N
31317) in the light housing. Use of any other bulb
within the housing will generate excessive heat,
causing damage to the light housing and cabinet
interior, and will compromise the precise
temperature control of your unit.
3. Replace the bulb only with a genuine U-Line P/N 31317
replacement.
4. Replace the lens by first inserting the tab side back into
the housing at a slight angle. While gently pushing the
lens towards the tab end, push the free end up into the
housing, and release when you will hear a snap/click.

Wine Rack Removal/Installation

To remove a rack from the cabinet:
1. Grasp the end of the rack, and gently slide it out until
it stops.
2. Remove any bottles stored on the rack.
3. Press the left rack release lever (Figure 16) down, and
at the same time, lift the corresponding right rack
release lever up, and pull the rack out until it is free of
the tracks and the cabinet.
Figure 16
IMPORTANT IMPORTANT
Do not remove the track side rails from the cabinet.
To insert a rack in the cabinet:
1. Align the left and right rack channels with the tracks
in the cabinet, and ensuring an even track
engagement on both sides, gently push the rack into
the cabinet until it stops.
2. Before reloading the rack, ensure proper operation of
the travel stops in the left and right track rails by
pulling the rack out gently until it completely stops.
ULIN_0162_A